Instructor: Brett Sutton

Location: Tualatin Training Center

CE Hours: up to 4 towards Annual Continuing Education Reimbursement Check

State Credits: n/a

Class Dates and Times:

Tue 7/15 4pm-8pm

Fees:

Local 290 Members: Free
UA Travelers: $35

Prerequisites: n/a

Needed Materials:

Pen/pencil, notebook paper, Straight Edge, Soap Stone/Paint Marker, Pipe Trades Pro calculator (recommended but not required).

Class Description:

The goal of this course is to practice designing, fabricating and installing pipe without stove-piping. This course will walk you through setting up a Ridgid 300 threading machine, and setting dies, detailing and drawing isometrics to UA standards. This course is recommended for all apprentices and journeymen including those practicing for the Building Trades Review.

Class Cancellations: If this class has less than 6 students registered at the close of registration the class may be canceled. If the class is cancelled, you will be notified via email and any fees paid will be refunded to the original payment method.

A Note on State Credits: State Credit will only be earned for courses that have been approved by the state. If a class is approved for credit, it will be noted in the class description. To receive state credit for a class you must attend all hours of the class. Courses are approved by the state for a fixed number of credit hours. These hours cannot be edited when submitting license numbers for credit.

602 Pipe Threading Skills Development -7.15.25