Combustion Safety and Building Analyst (C236)
$0 – $350
Combustion Safety and Building Analyst (C236)

Combustion Safety and Building Analyst (C236)

Event Information

Share this event
Date and Time
Location
Location

Building Performance Center

3406 Redwood Avenue

Bellingham, WA

View Map

Event description

Description

A Note About Ticket Types:  

There are three different Ticket Types. You will need to choose the appropriate one in order to register. 

WA State Weatherization (WX) Agency, Tribal, or WA State Department of Commerce Staff:
Those who are employees of a Commerce-recognized WA State Wx Agency, a staff member of one of WA State's Tribes (with approval by Commerce), or Commerce staff. The list of Commerce-recognized WA State Weatherization Agencies can be viewed here


WA State Wx Agency-Associated Contractor:
Contractors working under one of the WA State Wx Agencies (see above).  At registration, you will be required to list the WA State Wx Agency(ies) you are associated with.

General Public/Non-Associated Contractor:
Those who neither work for nor under (as a contractor) one of the WA State Wx Agencies (see above). 

 

Session Description

Combustion Safety and Building Analyst Training 

8 hours

Cost:  $350.00

BPI CEUs:  4 

This workshop  focuses on basic safety testing of combustion appliances. Procedures to determine appliance drafts will be reviewed. Proper use of the digital manometer, draft gauges, chemical smoke and techniques for resolving pressure problems will be emphasized. This is not a combustion appliance repair course, this course is about identifying existing problems and predicting how house tightening or duct repair will cause problems, or make existing problems worse.

Learning Objectives

1.  Review products of complete combustion and incomplete combustion.

2.  Understand the effects of carbon monoxide and other products of combustion on home and occupants.

3.  Know where to reference carbon monoxide action levels and the appropriate action to take for protection of technician and occupant health.

4.  Be able to inspect and identify problems with exhaust pipe: corrosion, configuration etc.

5.  Be able to inspect and identify problems with the wiring of the appliance: melted, corroded etc.

6.  Be able to identify the combustion appliance zone.

7.  Be able to identify the type of combustion appliance (furnace, water heater, space heater etc.) and it’s venting type (atmospheric, induced, direct).

8.  Understand the effects of building tightness, exhaust ventilation, and duct leakage on the ability of an appliance to draft.

9.  Obtain a working knowledge of solutions available to correct to pressure-induced drafting problems.

10.  Obtain a working knowledge of methods used to lower carbon monoxide levels in the exhaust of appliances.

11.  Be able to make appropriate recommendations from information gathered according to established standards.

Be able to conduct the following tests:

  1. Combustion Appliance Zone (CAZ), worst-case set up
  2. Measurement of depressurization in the CAZ
  3. Measurement of draft in the exhaust pipe or flue under worst-case and best-case conditions
  4. Measure carbon monoxide levels in ppm in ambient air and undiluted exhaust
  5. Know where and how to test for spillage
  6. Know where and how to test for gas leaks

 

***IMPORTANT:  Once you are registered, you will be able to download Study Packet documents, including the BPI technical standards, sample test questions and recommended study materials for the Building Analyst certification. The orientation packet will provide you with the information you need to prepare for the certification exam and an overview of BPI's standards and code of conduct. It is strongly recommended candidates review combustion safety testing and action levels before the exam.***

Share with friends
Date and Time
Location

Building Performance Center

3406 Redwood Avenue

Bellingham, WA

View Map

Save This Event

Event Saved